Full Product Manual

100603 - INVERTER GENERATOR COVER STEP 5: CONNECT THE EXTENDER ARMS
10
STEP 5: CONNECT THE EXTENDER
ARMS
Properly installed Extender Arms will make a rectangle
around the inverter viewed from above the Inverter
generator. See Figure 14.
The first Extender Arm for each corner snaps into
the Angle Brace. Additional Extender Arms can then
be snapped in place as needed to get the full-length
extender arm required. Installation begins at the Angle
Braces connected to the exhaust side. Once these are
set in place and adjusted to ensure exhaust gases will
be dispelled and not collected inside the canopy, simple
measurements can take place to set the remaining
Extender Arms.
How To Connect An Extender To An
Angle Brace
IMPORTANT: Hold the Extender so that the Rod Holes
are pointing upward.
– Refer to Figure 2 and Figure 3.
– Align the Extender Arm prongs into the installation
slots at the top and bottom of the Angle Brace.
– Push the Extender Arm straight into the Angle Brace
until the pivot pins snap into place.
Figure 10: Connect Extender to Angle Brace
How To Connect An Extender To An
Installed Extender
IMPORTANT: Hold the Extender so that the Rod Holes
are pointing upward.
– Refer to Figure 3.
– Align the Extender Arm prongs with the receiver slot
in the installed Extender.
– Push the Extender Arm straight into the already
installed Extender Arm until the pivot pins snap into
place.
Figure 11: Connect Extender to Extender
Install Extenders Onto Exhaust Side
Of The Inverter Generator
IMPORTANT: Refer to Figure 14
– Move to the exhaust side of the Inverter Generator.
The objective is to find a span of 23" to 25"
between the rod holes of the two corners.
– Install the first Extender arm into the Angle Brace.
– Adjust the Extenders across the Angle Brace
Adjustment Teeth to their furthest positions away
from the inverter case (position -2 and +2 in the
diagrams below.
Figure 12: Angle Brace Tooth Numbering
– To find the correct frame rod holes, determine
which of the holes (1 – 4) on the extender are
closest to between 23" and 25" apart. Important:
Measure between the same holes (1 -4) on the
Angle Braces.