Full Product Manual

100603 - INVERTER GENERATOR COVER COVER IT: SECURE STORM SHIELD CANOPY OVER FRAME
13
COVER IT: SECURE STORM SHIELD
CANOPY OVER FRAME
Position Storm Shield canopy over the frame. Be certain
that the fueling door is not on the same side as the
generator exhaust
Slide Storm Shield canopy over the frame so that all four
corners are generally equal and level.
Center Storm Shield canopy such that Vent Rod is
centered under the top cap.

NOTICE
Be certain that the fuel door opening does not catch
behind the fiberglass rods. The rods should always
be tucked into the seams. This can be checked by
opening the door after installation.
Slide one corner elastic over the corresponding Extender
Arm, under the Extender Arm, in a scallop behind a set
of retention pins.
Repeat on opposite corner, then on the remaining two
corners. Recheck and adjust canopy if necessary.
SELECT AND INSTALL ELECTRICAL
APRON
– If your electrical outlets are on the short side of
the generator, select the short electrical apron;
otherwise select the long electrical apron. Only use
one apron!
– Flip the canopy over flap up from corner to corner
on the side that is over the electrical outlets
(figure 16).
– The left and ride sides of the electrical apron
are angled upward slightly as compared to the
main body of the apron. The angle starts about 6
inches from either side and this corresponds to the
respective corner of the Storm Shield. Press either
corner on first (Figure 16), then wrap the 6-inch
section onto the adjacent side of the electrical panel
and press firmly. Now press the main apron body
over the electrical panel to the other corner, and
then wrap that edge around the adjacent side and
press firmly in place.
– Flip the over flap down and over the electrical apron
(figure 16).
Figure 16: Canopy Over Flap Exposed and then Closed