Manualshelf

Full Product Manual

ManualsBrandsChampion Power Equipment ManualsAccessoriesStorm Shield Severe Weather Portable Generator Cover in Yellow
78910111213141516
100603 - INVERTER GENERATOR COVER IMPORTANT STORM SHIELD USAGE TIPS
14
NOTICE
The intent of the electrical apron is to cover the
electrical outlets in the front and about 6" around
the adjacent sides. Do not cover other parts of your
generator with the electrical aprons, especially the
exhaust area!
IMPORTANT STORM SHIELD
USAGE TIPS
Proper Door Sealing Tip
– The Storm Shield door wraps around the adjacent
sides of the Storm Shield. Each time you close the
door, it must be pressed firmly back in place. If this
is not done, holes may exist between the pieces of
Velcro® which can allow water to seep in:
– Align the door properly so that the side Velcro
and lower Velcro are aligned as closely as
possible and are touching.
– Then starting at the top corner of the door pinch
canopy around the frame rods and slide your
hand to the bottom while pinching.
– Repeat on the other side.
– Check the door sides to see if you can see any
gaps in the Velcro sealing. Should there be any
gaps, repeat the pinching procedure.
NOTICE
Pull the door down and connect the bottom Velcro
first, then use the pinch & slide technique above to
secure the sides. The bottom edge should cover the
under-flap stitching!