Full Product Manual

100603 - INVERTER GENERATOR COVER PACKAGE CONTENTS
5
PACKAGE CONTENTS
Storm Shield is suitable for inverter case perimeters
up to 112"
Storm Shield 10k sized Canopy (Standard or Extreme
Edition) including electrical covering aprons .............. 1
40” Fiberglass frame rods ......................................... 4
Associated Hardware Pack Contains:
114” Kevlar
®
Ratchet Buckle ..................................... 1
Angle Brace corner sections ...................................... 4
Storm Shield Gator Grommets™ ............................... 8
Extender Arms..........................................................12
Central Connector for Frame Rods............................. 1
INSTALLATION OVERVIEW
The Storm Shield 100603 installs in three easy steps:
Strap it: Install Ratchet Buckle, Angle Braces, and
Extension Arms.
Frame it: Install frame rod to the center connector, then
into the correct hole in the Extender Arm, and repeat on
all four corners.
Cover it: Slide the Storm Shield canopy over the frame,
then secure by sliding the elastic straps under the
Extender Arm.
Important Usage Tips:
Storage
The Storm Shield can be left installed for generator
storage, or easily removed and stored separately. We
recommend releasing the elastic straps when storing
away from wind.
Maintenance
The Storm Shield assembly can be removed for
maintenance - release the ratchet buckle and carefully
lift the entire assembly off the inverter and place aside.
Reverse the operation to reinstall.
Transport
For transport remove the Storm Shield Canopy, Shield
Frame and the Extender Arms; leave the Angle Brace
strap mount in place.
Strap It: Install the Ratchet Strap
Mount

NOTICE
The following steps are done for initial installation.
Once installed the first time, the entire strapped
assembly can be taken off and reinstalled quickly
and easily.
Getting Familiar with the Angle Brace and Extender
Arms
Figure 1: Corner Mount Components
The Angle Brace and Extension arms work together
with the Kevlar ratchet buckle system to create a stable
and strong mounting point for the Storm Shield on your
inverter generator. Please familiarize yourself with these
components:
– Kevlar strap – this strap is black and 1" wide. It is
installed through the Angle Braces. It is attached to
a ratchet buckle for tightening the assembly to your
inverter case.