Full Product Manual

100603 - INVERTER GENERATOR COVER STEP 4: STRAP THE ASSEMBLY TO THE INVERTER CASE
8
IMPORTANT: Thread the end of the strap through the
Angle Brace so that the strap goes behind the center
section of the Angle Brace and lays flat against the
corner guides as shown below.
Figure 8: Kevlar Strap Correctly Installed through Angle Brace
STEP 4: STRAP THE ASSEMBLY TO
THE INVERTER CASE
How To Install And Tighten The
Ratchet Buckle
Ratchet Tie Down Buckle Tightening Instructions
4. From bottom, thread Kevlar strap through the slot
in the center spool of closed ratchet (figures A and
B below).
5. Pull strap through, removing the slack (figure C
below).
6. Tighten the strap by ratcheting (opening and
closing the handle) (figure D below).
Figure A
Figure B
Figure C
Figure D
Figure E