OPERATOR'S MANUAL MODEL #100781 3000 PSI Pressure Washer REGISTER YOUR PRODUCT ONLINE at championpowerequipment.com or visit championpowerequipment.com SAVE THESE INSTRUCTIONS. This manual contains important safety precautions which should be read and understood before operating the product. Failure to do so could result in serious injury. This manual should remain with the product.
Table of Contents 100781 - 3000 PSI Pressure Washer TABLE OF CONTENTS Maintenance................................................. 19 Cleaning the Pressure Washer.......................... .......... 19 Introduction.................................................... 3 Cleaning Spray Nozzle............................................ 19 Safety Definitions........................................... 3 Changing the Engine Oil................................ .......... 19 Important Safety Instructions..
Introduction 100781 - 3000 PSI Pressure Washer INTRODUCTION SAFETY DEFINITIONS Congratulations on your purchase of a Champion Power Equipment (CPE) product. CPE designs, builds, and supports all of our products to strict specifications and guidelines. With proper product knowledge, safe use, and regular maintenance, this product should bring years of satisfying service. The purpose of safety symbols is to attract your attention to possible dangers.
Important Safety Instructions 100781 - 3000 PSI Pressure Washer IMPORTANT SAFETY INSTRUCTIONS WARNING Spark from removed spark plug wire can result in fire or electrical shock. WARNING Cancer and Reproductive Harm – www.P65Warnings.ca.gov When servicing the pressure washer: Disconnect the spark plug wire and place it where it cannot contact the plug or any other metal object. DANGER Pressure washer exhaust contains carbon monoxide, a colorless, odorless, poisonous gas.
Important Safety Instructions 100781 - 3000 PSI Pressure Washer NOTICE WARNING NEVER spray flammable liquids or use pressure washer in areas containing combustible dust, liquids, or vapor. Improper treatment or use of the pressure washer can damage it, shorten its life and void your warranty. NEVER operate this machine in a closed building or in or near an explosive environment. Use the pressure washer only for intended uses.
Important Safety Instructions 100781 - 3000 PSI Pressure Washer When adding or removing gasoline: WARNING – DO NOT light or smoke cigarettes. High pressure spray can splash back at operator or propel objects. – Always turn the pressure washer off and let cool for a minimum of two minutes before removing the gasoline cap. Afterwards, loosen gasoline cap to relieve pressure from the gasoline tank. NEVER: allow children to operate any pressure washer or play nearby.
NOTICE AVISO AVIS 10W-30 C D E 5 WARNING ADVERTENCIA AVERTISSEMENT L'APPAREIL NE CONTIENT PAS D’HUILE! En ajouter avant le démarrage. Utilisez uniquement de l’huile 10W-30 vérifiez et changez l’huile par le manuel du moteur Honda. DO NOT TOUCH! Exhaust gases, muffler and engine components are extremely HOT and cause burns. Operation of this equipment may create sparks that can start fires around dry vegetation. A spark arrestor may be required.
Important Safety Instructions 100781 - 3000 PSI Pressure Washer Safety Symbols Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to more safely operate the product. SYMBOL MEANING Read Operator’s Manual. To reduce the risk of injury, user must read and understand operator’s manual before using this product. Electric Shock.
Important Safety Instructions 100781 - 3000 PSI Pressure Washer Operation Symbols Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to more safely operate the product. SYMBOL MEANING SYMBOL MEANING 0° Nozzle 40° Nozzle 15° Nozzle Soap Nozzle 25° Nozzle Quickstart Label Symbols Some of the following symbols may be used on this product. Please study them and learn their meaning.
Controls and Features 100781 - 3000 PSI Pressure Washer CONTROLS AND FEATURES Read this operator’s manual before operating your pressure washer. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference. 1 2 3 11 4 10 7 6 9 5 12 8 13 14 22 21 23 20 24 15 16 19 17 18 Pressure Washer 1. Upper Handle 6. Wheels 11. High Pressure Hose Storage Strap 2. Nozzles 7. Detergent Tank Cap 12. Detergent Barb 3. Trigger Gun 8.
Controls and Features 100781 - 3000 PSI Pressure Washer Parts Included Part Wheels Part Qty. 2 Support Leg 2 Detergent tank 1 Detergent hose 1 Top handle 1 Trigger gun 1 Spray wand 1 Nozzle"0", 00027 1 Nozzle "15", 15027 1 Nozzle "25", 25027 1 Nozzle "40", 40027 1 Nozzle "Detergent", 65400 1 Trigger gun holder 1 High pressure hose, 25ft. 1 Hose strap 1 Engine oil, 0.
Assembly 100781 - 3000 PSI Pressure Washer ASSEMBLY Support Legs 1. Attach the supports legs to the pressure washer frame with 2 M8 x 45 flange bolts and 2 M8 flange lock nuts per leg. Tighten to 8.8 ft-lb − 10.3 ft-lb (12-14 Nm). Your pressure washer requires some assembly. This unit ships from our factory without oil. It must be properly serviced with fuel and oil before operation. If you have any questions regarding the assembly of your pressure washer, call our help line at 1-877-338-0999.
Assembly 100781 - 3000 PSI Pressure Washer Nozzles Trigger Gun Holder 1. Nozzles are stored in the top panel. To store the nozzle, press it into the corresponding opening. To remove the nozzle, just pull the nozzle out. 1. Align the trigger gun holder to the frame. 2. Attach to the frame with 2 M6 x 45 flange bolts and M6 nuts. Tighten to 8.8 ft-lb − 10.3 ft-lb (12-14 Nm). Do not overtighten. High Pressure Hose Strap The High pressure hose storage strap is provided to store your hose when not in use.
Assembly 100781 - 3000 PSI Pressure Washer Attach the Trigger Gun Assembly 1. Attach the spray wand to the trigger gun. 2. Rotate (clockwise) the M22 coupler on the trigger gun until the spray wand is secure. Do not overtighten. NOTICE Be careful to avoid cross-threading, which can cause the trigger gun to leak during use. 5. Gently pull on the hose to be certain it is properly secured. 3.
Operation 100781 - 3000 PSI Pressure Washer OPERATION NOTICE Do not run the pressure washer without water supply connected and turned on, as this may damage the high pressure seals and decrease pump life. Completely unwind the hose from its reel or coil and make sure the hose is not being restricted by tires, rocks, or any other objects that may lessen or prevent water flow to the pressure washer. Pressure Washer Location This pressure washer must have at least 5 ft. (1.
Operation 100781 - 3000 PSI Pressure Washer Distance from Cleaning Surface The distance between the spray nozzle and the cleaning surface is another factor that affects the impact force of the water. The impact force of the water increases as the nozzle is moved closer to the surface. You can vary the impact force by controlling – The nozzle’s fan pattern. – The nozzle’s angle to the cleaning surface. – The nozzle’s distance from the cleaning surface.
Operation 100781 - 3000 PSI Pressure Washer High Pressure Wash NOTICE CAUTION Use only detergents designed for pressure washers. Do not use household detergents, acids, alkalines, bleaches, solvents, flammable material, or industrial grade solutions, which can damage the pump or cause property damage. Many detergents may require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle. Always test in an inconspicuous area before beginning.
Operation 100781 - 3000 PSI Pressure Washer 4. Connect the other end of the detergent suction hose to the detergent barb on the pump. To reduce the risk of bodily injury or property damage, always follow this procedure whenever spraying is stopped, when work is completed, and before checking or repairing any part of the system. 1. Engage the trigger gun lock out. 2. Turn the unit off. 3. Shut off the water supply. 4. Disengage the trigger safety latch and trigger the gun to relieve pressure. 5.
Maintenance 100781 - 3000 PSI Pressure Washer Stopping the Engine Cleaning the Pressure Washer 1. After stopping the engine per Honda’s owner/operator manual, depressurize system by pressing the trigger gun to release any trapped pressure. CAUTION DO NOT spray the pressure washer with water. 2. Turn off water supply and disconnect all hoses. Water can contaminate the fuel system and can enter the engine through the cooling slots and damage the engine.
Storage 100781 - 3000 PSI Pressure Washer STORAGE SPECIFICATIONS Refer to the Maintenance section for proper cleaning instructions. Pressure Washer Specifications Pressure Washer Storage Model.................................................... .... 100781 1. Allow the pressure washer to cool completely before storage. Max Pressure.. ............................................. 3000 PSI 2. Turn off the fuel supply at the fuel valve. Max Volume............................................. .... 2.
23 21 22 23.1 31 30 27 29 28 21 20 32 18 19 33 16 25 24 17 34 27 13 14 12 15 26 35 11 36 13 10 9 27 37 13 8 5 7 6 41 40 4 23.
Specifications 100781 - 3000 PSI Pressure Washer Parts List Qty. # Part Number 1 # GC160 Part Number Engine, 160cc Description 1 30 122.201400.04.29 Rubber, Support 2 2 2.14.001 Key, SQ 4.78 x 4.78 x 40 1 31 1.5789.0825 Flange Bolt M8 x 25 2 3 2.08.010 Bolt 5/16-24 x 22 4 32 122.201501.00 Pin Roll, Wheel 2 4 1.93.08 Lock Washer Ø8 4 33 254.201702.04.48 Cap, Wheel, Yellow 2 254.201701.04.48 Wheel, PU,Yellow 2 Description Qty. 5 252.251003.
Troubleshooting 100781 - 3000 PSI Pressure Washer TROUBLESHOOTING Problem Cause Solution No fuel. Add fuel. Faulty spark plug. Replace spark plug. Pressure washer will not start; Low oil level. Pressure washer starts but runs roughly. Fill crankcase to the proper level. Place pressure washer on a flat, level surface. Choke in the wrong position. Adjust choke. Spark plug wire loose. Attach wire to spark plug. Pressure washer gallops. Engine governor defective. Contact the help line.
WARRANTY* Other Exclusions CHAMPION POWER EQUIPMENT This warranty excludes: 2 YEAR LIMITED WARRANTY – Cosmetic defects such as paint, decals, etc. – Wear items such as filter elements, o-rings, etc. Warranty Qualifications To register your product for warranty and FREE lifetime call center technical support please visit: https://www.championpowerequipment.com/register To complete registration you will need to include a copy of the purchase receipt as proof of original purchase.