Use and Care Manual

ManualsBrandsChampion Power Equipment ManualsTools & HardwareWireless Remote Winch Kit 18029 for 2,000-4,500 lb. Champion Winches

OWNER’S MANUAL & OPERATING INSTRUCTIONS

WIRELESS REMOTE KIT

WINCH

10006 Santa Fe Springs Road

Santa Fe Springs, CA 90670

USA / 1-877-338-0999

www.championpowerequipment.com

SAVE THESE INSTRUCTIONS

Important Safety Instructions

are included in this manual.

MADE IN CHINA

REV 18029-20111222

18029

MODEL NUMBER

Summary of content (8 pages)

PAGE 1
OWNER’S MANUAL & OPERATING INSTRUCTIONS WInCH WIreless remote KIt MODEL NUMBER 18029 saVe tHese InstruCtIons Important Safety Instructions are included in this manual. MADE IN CHINA REV 18029-20111222 10006 Santa Fe Springs Road Santa Fe Springs, CA 90670 USA / 1-877-338-0999 www.championpowerequipment.
PAGE 2
Have questions or need assistance? Do not return this product to the store! WE ARE HERE TO HELP! Visit our website: www.championpowerequipment.
PAGE 3
18029 ENGLISH Controls and Features Winch Wireless Remote Kit *Mounting hardware not shown. 2 3 1 5 4 6 (1) Wireless Remote Control – Used to power the rope in or out of your winch drum. (2) Antenna – Receives wireless signal from wireless remote control from within a 50 ft. radius. (3) Rocker Switch – Rocker switch with handlebar mount for powering the rope in or out of your winch drum.
PAGE 4
ENGLISH 18029 Assembly 1) Install Solenoid/Contactor Find a location for the contactor. If the model specific mounting kit does not indicate a recommended contactor location, then it is recommended that the contactor be mounted close to the battery in a clean dry location. Make sure the location you chose allows sufficient clearance from all metal components. Drill mounting holes if required. Once location is found do not install until all wiring is completed. 2) Install Rocker Switch 1.
PAGE 5
18029 ENGLISH Assembly 4) Install the Antenna 5) Test Winch Operation 1. Determine the mounting location. 2. If mounting on a flat surface, mark and drill a minimum of two (2) mounting holes, one on each side of the antenna. Loosely attach the antenna using the supplied bolts and lock nuts. Do NOT tighten fasteners at this time. 3. If mounting on a frame tube, loosely attach using the supplied cable ties. 4. Locate the black and green wires running from the contactor to the rocker switch.
PAGE 6
ENGLISH 18029 Assembly Solenoid/Contactor Wiring Diagram Negative (–) Blue Yellow Positive (+) Black Negative (–) To Switch And Remote Wiring Red 6 REV 18029-20111222 Positive (+)
PAGE 7
Assembly 18029 ENGLISH Antenna Wiring Diagram Green Black & White Black Green To Ground on Solenoid/Contactor Green Black Red Ignition Wire 7.
PAGE 8
ENGLISH 18029 Warranty WARRANTY CHAMPION POWER EQUIPMENT 2 YEAR LIMITED WARRANTY Warranty Qualifications Champion Power Equipment (CPE) will register this warranty upon receipt of your Warranty Registration Card and a copy of your sales receipt from one of CPE’s retail locations as proof of purchase. Please submit your warranty registration and your proof of purchase within ten (10) days of the date of purchase.