Use and Care Manual

15
200946 - 3 IN. (7.6 CM) CHIPPER SHREDDER
ASSEMBLY
ASSEMBLY
Your chipper-shredder requires some assembly. This unit ships
from our factory without oil. It must be properly serviced with fuel
and oil before operation.
If you have any questions regarding the assembly of your chipper-
shredder, call our Technical Support Team at 1-877-338-0999.
Please have your serial number and model number available.
Unpacking
1. Set the shipping crate on a solid, flat surface.
2. Carefully cut the shipping bands and remove lid of shipping
crate.
3. Locate all hardware before beginning assembly.
1) Install the Chipper Chute
1. Align the holes on the base of the chipper chute with the
threaded studs on the impeller housing and push the chipper
chute flush against the impeller housing.
2. Thread the M8 lock nuts onto the threaded studs and tighten
securely using a 12mm socket or wrench.
2) Install the Shredder hopper Support
Bracket
1. With the angled part of the bracket pointing towards the
engine, align the holes of the bracket with the holes on the
top of the flail housing.
2. Insert two M8 × 20 flange bolts through the holes on the flail
housing and shredder hopper support bracket from the flail
housing side.
3. Thread two M8 lock nuts onto the flange bolts and tighten
securely using 12mm and 10mm sockets or wrenches.
3) Install the Shredder hopper
1. Insert the shredder hopper into the top of the flail housing
with the handle slot cutouts facing the rear of the unit
(towards the wheels). Slide the threaded studs on the angled
part of the shredder hopper into the slots on the shredder
hopper support bracket that was installed in step 3 while also
ensuring that the slots on the bottom of the shredder hopper
slide over the locator pins that are inside the flail housing.
Ensure that the four holes on the shredder hopper are aligned
with the 4 holes on the flail housing (1 on either side and 2 on
the rear).
2. Thread two M6 lock nuts onto the threaded studs to secure
the shredder hopper to the shredder hopper support bracket
and tighten securely using a 10mm socket or wrench.
3. Insert four M6 × 15mm flange bolts through the four holes
of the flail housing and into the weld nuts in the shredder
hopper. Tighten securely with a 10mm socket or wrench.
4) Install the Discharge Chute Deflector
1. Align the hinge on the top of the chute deflector with the tab
on top of the discharge chute so the tab is aligned in the slot
in the middle of the hinge.
2. Insert the M6 × 55mm flange bolt through the hinge and tabs
with holes on the top of the discharge chute.