Use and Care Manual

16
200946 - 3 IN. (7.6 CM) CHIPPER SHREDDER
ASSEMBLY
3. Thread the M6 lock nut onto the threaded stud to secure the
chute deflector to the discharge chute.
4. From both sides, insert a knob bolt through the slotted hole
on the chute deflector and into the threaded hole on the
discharge chute. Select your desired position for the chute
deflector and then hand tighten the knob bolts to secure the
chute deflector in place.
Collection Bag
The collection bag can be attached and removed from the chute
deflector using the adjustable drawstring. It is recommended to
be attached before operation and removed before completely full,
after operation, or before storage. The collection bag will collect
up to 2 bushels (70 L) of material.
 WARNING
Before operation, ensure the adjustable drawstring is tight
around the chute deflector and secure.
 WARNING
When the collection bag appears to be almost full, it is
recommended to empty it. This will help to keep the bag from
becoming dislodged from the deflector chute and will also
prevent the bag from bursting. Do not allow the collection
bag to become dislodged from the deflector chute during
operation. If this occurs, stop operation at once and reconnect
the collection bag. Always empty the collection bag when the
engine is off and the spark plug has been disconnected.

NOTICE
Always inspect the collection bag prior to use. Do not use a
frayed, worn, or damaged collection bag.
Add Engine Oil
 CAUTION
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the engine as a result of failure to follow these
instructions will void your warranty.

NOTICE
The recommended oil type is 10W-30 automotive oil.
1. Place the chipper-shredder on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel, add up to 20.3 fl. oz (600 ml) of oil (included)
and replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level before every use and add as needed.
MAX
OIL DIP STICK

NOTICE
Once oil has been added, a visual check should show oil about
1-2 threads from running out of the fill hole.
If using the dipstick to check oil level, DO NOT screw in the
dipstick while checking.

NOTICE
Check oil often during the break-in period. Refer to the
Maintenance section for recommended service intervals.