Owners Manual

ManualsBrandsChampion Power Equipment ManualsGenerators3500-Watt Dual Fuel Portable Generator with Intelligauge, Covered Outlets, Cold Start Technology and Carb Compliant in Black and Yellow

Table Of Contents

200966 - 3500W DUAL FUEL PORTABLE GENERATOR

ASSEMBLY

Your generator requires some assembly. It must be properly

serviced with fuel and oil before operation.

If you have any questions regarding the assembly of your

generator, call our Technical Support Team at 1-877-338-0999.

Please have your serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, ﬂat surface.

2. Remove everything from the carton except the generator.

3. Carefully cut each corner of the box from top to bottom. Fold

each side ﬂat on the ground to provide a surface area to work

with the generator.

Remove Shipping Support Brackets

To protect the generator during shipping, support brackets have

been installed between the engine and frame. These brackets

MUST BE REMOVED BEFORE adding oil or gasoline to the

generator.



NOTICE

DO NOT attempt to run generator without ﬁrst removing the

shipping support brackets. Damage to the generator as a result

of not removing the brackets will void the warranty.

1. BEFORE ﬁlling the engine with oil or gasoline, tip the

generator onto its recoil end. Tip onto the ﬂattened cardboard

box the generator came in or other protective surface so as to

not scratch the frame.

2. Remove the bolts from the orange support brackets. Bolts

and brackets can be discarded.

3. Tip the generator upright.

Install the Wheel Kit

 CAUTION

The wheel kit is not intended for over-the-road use.

Install the Wheels

1. Before adding fuel and oil, tip the generator onto it’s recoil

end.

2. Remove wheel hub cap (B) from wheel by inserting a small

screwdriver into the slot provided and pry upward.

3. Slide the roll pin (C) through the wheel (A) from the outside.

4. Slide the roll pin through the mount point on the frame.

5. Insert r-clip (D) into hole at end of roll pin.

6. Re-install hub cap on wheel.

7. Repeat to attach the second wheel.

Install the Support Leg

1. Attach the support leg (E) to the generator frame with ﬂange

bolts (F) and ﬂange lock nuts (G).

2. Slowly tip the generator back down so that it rests on the

wheels and support Leg.