Installation Guide

HOME STANDBY GENERATOR- ALL aXis CONTROLLER
®
MODELS
INSTALLATION
35
or exhibit a glaze, which can create a resistance to the flow
of electricity. This can occur when the HSB is not exercised or
ran over long periods of storage.
AVR
CONNECTORS
1
2
3
Slotted potentiometer is factory set to the correct voltage and
should not require adjustment.
H 102
3028
Engine Relay Module
14-KW (MODEL 100515)
This module is the interface between the Engine Controller, ATS
Controller, alternator, hour meter and battery charger. It is the
interface for all on board communications in the HSB.
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL START STOP B+ B-
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL S
40A FUSE
5A FUSE
100417
22-KW (MODEL 100304)
The module has two (2) fuses built into the board.
1. A 250VAC 5A mini fuse protecting the system from an over
voltage between the alternator and the relays. Remove
plastic FUSE cover to access.
100417
40A FUSE
5A FUSE
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL START STOP B+ B-
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL S
2. An automotive style fuse, 40A (Orange), which protects the
system from an excessive transfer voltage output when
the ATS relays transfer between utility and generator and
generator to utility modes. Remove plastic FUSE cover to
access.
100417
40A FUSE
5A FUSE
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL START STOP B+ B-
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL S
TOP ROW
There are 12 wire land points in the top row, the connection points
are all the same size.
100417
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL START STOP B+ B-
FREQ FREQ ATS IN.1 WATR OIL ALT FUEL START STOP B+ B-
40A FUSE
5A FUSE
The following are the wire land points, function and wire color, left
to right.
Wire Land
Points
Function Wire Color
Position #1 Frequency R (Red)
Position #2 Frequency B (BLACK)
Position #3 Not connected Empty