Replacement Part List

100593 - 3200 PORTABLE POWER STATION
INITIAL USE
21
1. Remove the rubber plug covering the DC input port and
connect the APP end of the Easy Connect DC Solar Charge
Harness (included) to the APP input port on the back of the
Power Station.
2. Connect up to three solar panels using the MC4 connectors.
3. If not using all 3 connections, you can remove any spare
connectors and store in a safe and dry location.
Recommended Solar Panels

NOTICE
It will not damage, and often times is necessary, to use more
than the 440W of solar panels to achieve actual 440W of
charging.
Always use panels with the same nominal voltage rating when
using multiple solar panels.
Model Watts Connector Type
Renogy RNG-100D-SS 100 MC4
Renogy Solar Panel 200
Watt 12 Volt
200 MC4
Bluetti SP120 120 MC4
Bluetti SP200 200 MC4
ECOFLOW EFSOLAR
160W
160 MC4
Any solar panel rated between 10-28V with MC4 or APP
connectors can be used. The Power Station has a built in MPPT
and inverter so there is no need to buy an external charge
controller, inverter, or worry about connecting more than 440W of
solar panels to reach 440W of input on cloudy days.
Using APP Port
(For Solar Panels with APP connector)
1. Connect the solar panel to the APP input port on the back of
the Power Station. Be sure to connect the red lead to red side
of port and black lead to black side of port.
Any solar panel rated between 10-28V with MC4 or APP
connectors can be used. The Power Station has a built in MPPT
and inverter so there is no need to buy an external charge
controller, inverter, or worry about connecting more than 440W of
solar panels to reach 440W of input on cloudy days.