Replacement Part List

100593 - 3200 PORTABLE POWER STATION
INITIAL USE
22
OPERATION
Using the Power Station
1. Press and hold the power button for three seconds, until
display illuminates.
2. Open the plastic cover to gain access to outlets.
3. The DC Output side is always powered on. Press the power
button for one second to power AC outlets.

NOTICE
To protect sensitive electronics, as the Power Station’s battery
level drops below 30%, THD Shield is designed to shut off
AC power output when the AC running watts are too high
and it can no longer maintain a pure sine wave (<5% THD).
The letters “THD” will appear in red. See THD Shield (Total
Harmonic Distortion) section.
4. To turn THD Shield off, press THD Shield button 5x within
three seconds.
5. Plug in desired devices.
Standby Mode
The Power Station will remain in standby mode for 4 hours, then
shut off if it does not supply at least 5 watts to an external device
or appliance. It will not shut off if it is plugged in and charging.
When charging may not be possible and the AC outlets are
powered on, the Power Station consumes about the same amount
of power as one light bulb.
LED Light
1. To turn on LED low power mode press LED light button one
time. Press button one more time for high power mode.
2. Press again to turn LED light off.