Owner`s manual

Controls and Features
6 Rev 41111-20090414
Power Panel
(1) Ignition Switch – Flip switch to the
“On” position to start the generator. Flip to
the “Off” position to turn off the generator.
(2) Circuit Breakers – Protects the
generator against electrical overload.
(3) Voltmeter – Displays the output
voltage of the generator.
(4) 120 /240 V 30 A Twist-Lock –
Protected by a 25 A flip-to-reset circuit
breaker on each 120 Volt leg of the
receptacle. This receptacle powers 240 Volt
AC, single phase loads requiring up to 5000
watts, 120 Volt AC, 60 Hz, single phase loads
requiring up to 25 A or 3000 Watts of
power. If an L14-30P plug is wired for only
one 120 Volt leg (3-wire connection) then
this receptacle powers 120 Volt AC, 60 Hz,
single phase loads requiring up to 20.8 A or
2500 Watts of power.
(5) 120 V 20 A Duplex – This duplex is
protected by a 20 A flip-to-reset circuit
breaker to operate 120 Volt AC, single phase,
60 Hz loads requiring up to 20 A 0r 2400
Watts of power.
(6) Ground Bolt – Consult an electrician
for local grounding regulations.