Instruction Manual

ManualsBrandsChampion Power Equipment ManualsPlumbing Product6.5 HP 2 in. Semi Trash and Water Transfer Pump with Hose Kit

REV 66520-20140303 12

66520 ENGLISH

MAINTENANCE AND STORAGE

The owner/operator is responsible for all periodic

maintenance.

Complete all scheduled maintenance in a timely manner.

Correct any issue before operating the semi-trash pump.

Never operate a damaged or defective semi-trash pump.

For service or parts assistance, contact our help

line at 1-877-33 8-09 99.

NOTE

Maintenance, replacement, or repair of emission

control devices and systems may be performed

by any non-road engine repair establishment or

individual.

NOTE

WARNING

Improper maintenance will void your warranty.

WARNING

Engine Maintenance

To prevent accidental starting, remove and ground spark

plug wire before performing any service.

Oil

Change oil when the engine is warm. Refer to the oil

speciﬁcation to select the proper grade of oil for your

operating environment.

1. Remove the oil drain plug with a 12 mm socket and

extension.

2. Allow the oil to drain completely.

3. Replace the drain plug.

4. Remove oil ﬁll cap/dipstick to add oil.

5. Add up to 0.6 qt. (0.6 L) of oil and replace oil ﬁll

cap/dipstick. DO NOT OVERFILL.

6. Dispose of used oil at an approved waste

management facility.

Spark Plugs

1. Remove the spark plug cable from the spark plug.

2. Use the spark plug tool that shipped with your semi-

trash pump to remove the plug.

3. Inspect the electrode on the plug. It must be clean and

not worn to produce the spark required for ignition.

4. Make certain the spark plug gap is 0.7 - 0.8 mm or

(0.028 - 0.031 in.).

5. Refer to spark plug section on speciﬁcations page.

6. Carefully thread the plug into the engine.

7. Use the spark plug tool to ﬁrmly install the plug.

8. Attach the spark plug wire to the plug.

Oil Cont’d.

0.7 - 0.8 mm

0.028 - 0.031 in.

Once oil has been added, a visual check should show

oil about 1-2 threads from running out of the ﬁll hole.

If using the dipstick to check oil level, DO NOT screw

in the dipstick while checking.

NOTE

Air Filter

1. Unscrew wing nut to remove the air ﬁlter cover.

2. Remove the foam element.

3. Wash in liquid detergent and water. Squeeze

thoroughly dry in a clean cloth.

4. Saturate in clean engine oil.

5. Squeeze in a clean, absorbent cloth to remove all

excess oil.

6. Reassemble the element.

7. Reattach the air ﬁlter cover and tighten wing nut.