User Manual

16
90720 - 7 TON FULL BEAM LOG SPLITTER
ASSEMBLY
Install the Engine
1. Align the 4 holes on the base of the engine with the 4 smaller
holes on the wheel mount.
2. Thread an M8×20 bolt (36) through an Ø8 Lock Washer (26)
and Ø8 Washer (27).
3. Thread a bolt and washers set through a hole on the bottom
of the wheel mount into the engine and tighten.
4. Repeat steps 1-3 for the remaining 3 bolt and washer sets to
complete mounting of the engine to the wheel mount.

NOTICE
The recoil side of the engine should point the same direction
as the beam as shown.
36
27
26
Install the Cylinder
1. Slide the cylinder pegs into the cylinder mounting slots on the
top of the beam.
2. Secure the cylinder retention plates (20) with M10×20 bolts
(23), Ø10 Lock Washers (22) and Ø10 Washers (21).

NOTICE
The recoil side of the engine should point the same direction
as the beam as shown.
20
23
22
21
Install the Bracket
1. Slide the ram bracket (2) over the rod on the cylinder being
sure to align the bolt holes.
2. Insert the M10×60 bolt (3) through the ram bracket and
cylinder rod.
3. Secure the bolt with M10 lock nut (1). Do not over tighten.

NOTICE
A screwdriver can be inserted into the cylinder rod’s bolt hole
to rotate to proper position prior to installing the ram bracket.
1
2
3
Install the Handle
1. Slide the handle (31) into the tube bracket on the end of the
beam.
2. Secure with cotter pin (32).
32
31
Install the Hoses
 CAUTION
Red shipping plugs must be removed from hydraulic pump
prior to installing hoses.

NOTICE
Hydraulic pump may contain residual oil from testing
procedures during production. We recommend using an oil tray
under the pump before removing the shipping plugs.