User Manual

100250 - 37 TON FULL BEAM LOG SPLITTER

ASSEMBLY

Your log splitter requires some assembly.

If you have any questions regarding the assembly of your log

splitter, call our help line at 1-877-338-0999. Please have your

serial number and model number available.

Open Shipping Crate

1. Set the shipping crate on a solid, ﬂat surface

2. Carefully cut the shipping bands and remove lid of shipping

crate.

3. Locate all hardware before beginning assembly.

1) Install the Hydraulic Oil Filter

1. Install the oil ﬁlter base onto the hydraulic oil tank. The barb

ﬁtting should be oriented vertically and once installed the oil

ﬁlter should be oriented so that it does not extend below the

hydraulic oil tank.

2) Install the Wheels

1. Remove the two plastic shipping caps from the wheel hubs.

2. Slide the wheel (27) onto the axle. Be sure the tire valve stem

is facing out.

3. Thread the castle nut (25) on the axle and tighten by hand.

Use a wrench to tighten another ¼ turn.

4. Spin the wheel (27) to distribute the bearing grease.

5. Loosen the castle nut (25) and re-tighten by hand.

6. Install the cotter pin (29) through the axle and castle nut. (25)

7. Check to be sure the wheel (27) spins freely.

8. Install the axle cap (24) using a soft face mallet or hammer

and wood block.

9. Repeat for the other wheel.



NOTICE

Keep dirt and debris away from the wheel bearings during

assembly.

 CAUTION

Over-tightening the castle nut will cause the bearings to run

hot and fail prematurely.

3) Install the Tow Bar

1. Attach the tow bar (57) to the bracket on top of the hydraulic

oil tank (30) with two M12x85 bolts (35), M12 washers (3)

and M12 lock nuts (2).