Owner`s manual

Champion Spas®

OWNER'S MANUAL

EQUIPMENT MAINTENANCE

Replacing the Spa’s Light Bulb

The spa’s light bulb is located inside the equipment compartment. Remove the front access

panel, by first removing the screws on the access panel. Then locate the light housing mounted

to the spa shell. Grasp the bulb holder on the back of the light niche. Turn bulb holder counter

clockwise to release it from the light niche. Pull bulb out of receptacle and replace it with a new

light bulb, available at your Champion Spas® dealer. Re-attach the light bulb holder to the light

niche by turning the light bulb holder clockwise.

CONTROL PANEL FUNCTIONS

MAIN CONTROL PANEL

The panel/topside will indicate the operations of the hydro jet pump(s), spa light, water

temperature and will display diagnostic symbols.

Champion Spas® models are equipped with a main control panel located on the top collar of the

spa. The main control panel controls all of the spa functions. It displays the spa’s status and any

diagnostic messages.

MAIN CONTROL PANEL BUTTONS AND DIGITAL DISPLAY

The main control panel has buttons, which the spa user presses to set the temperature, vary

the intensity of the light and activate or deactivate the hydro jet pump(s). The control panel

also has a digital display that displays the spas diagnostics (i.e.-temperature setting, jet functions

or error messages).

Temperature Control

The set temperature range is from 80°F (26°C) to 104°F (40°C). The temperature of the spa

water will automatically be 100°F (37°C) the first time that power is applied. This is the default

temperature setting programmed at the factory.

To display the set temperature of the spa, press the Temp button once.

To change the set temperature of the spa, press the Temp button a second time before the

display stops flashing. Each press of the Temp button will continue to either raise or lower the

set temperature.

If the opposite direction is desired, release the button and let the display revert to the current

water temperature. Press the Temp button to display the set temperature, and again to make the

temperature change in the desired direction.

After three seconds the display will stop flashing and display the current spa temperature.

Note: When first powering up the spa the water temperature will not be displayed until the

pump has been running for at least two minutes.

Note: The temperature shown on the display without pressing the Temp button reflects the

temperature of the water at that particular moment.