Owner`s manual

15
Champion Spas®
OWNER'S MANUAL
OPERATING THE H Y D RO PUMPS
Jets Button
Activates the hydro jet pump(s) for maximum hydrotherapy jet action. Press the Jets button
once for low speed, twice for high speed and a third time to turn the pump off. If your spa has
a two pump system there will be a one speed pump and a two speed pump. For the one speed
pump press the Jets button once for high speed and again to turn the pump off. When the
pump(s) are activated the indicator below the Jets button will light up. The pump(s) will shut-off
automatically after 15 minutes on high speed and 4 hours on low speed.
Note: The spa light will begin flashing 15 seconds before the pumps shut off as a reminder, that
the pump(s) cycle is about to end.
Note: Champion Spas® are designed for maximum heat retention. The unit is not designed
to cool water. If the set or desired temperature is below that of the ambient temperature, the
unit will not be able to achieve this demand. Depending on the desired temperature, it may be
necessary to add cool water to the unit to lower your spas water temperature.
Light Control Button
The spa light is controlled using the Light button. To turn on the spa light, press the Light
button. To turn off the light, press the Light button a second time. If the light is left on it will
automatically be turned off by the control system after two hours of continuous operation.
LED Lighting
See operational features and directions located in the box, or contact your dealer for instructions.
LED Lighting and LED Waterfall System
See operational features and directions located in the box, or contact your dealer for instructions.
Perimeter LED Lighting
See operational features and directions located in the box, or contact your dealer for instructions.
JetsJets LightJetsTemp