Owner`s manual

16
Champion Spas®
OWNER'S MANUAL
HEATING MODES
The heat mode on the Champion Spas® models are programmed to maintain the desired
temperature. Note that the last measured spa temperature displayed is current only when the
pump has been running for at least 2 minutes. "St" will be displayed momentarily when you are
in Standard Mode.
Preset Filter Cycle
The first filter cycle begins 6 minutes after the spa is powered up. The second filter cycle begins
12 hours later. Filter duration is programmable for 2, 4, 6, 8 hours or for continuous filtration,
which is indicated by "FC" on the display. The default filter cycle is 2 hours. To program, press
Temp button, then press Jets button. Then press Temp to select the number of hours you want
the tub to filter. Then press Jets to exit programming.
The low speed pump will run during the filtration cycles and the ozone generator will be
enabled.
Summer Set Mode
Your spa is equipped with this feature to prevent heat build up. The Summer Set Mode is
activated when the water temperature exceeds the set temperature by 3°F. When the Summer
Set Mode is activated it will suspend the filter cycle for 30 minutes, then Pump 1 will run on
low speed for 2 minutes. It will continue this way until the water temperature returns to the set
temperature.
Freeze Protection
If the temperature sensors detect a drop to below 44°F/6.7°C within the heater, the pump(s)
will automatically activate to provide freeze protection. After the sensors detect that the spa
temperature has risen to 45°F/7.2°C or higher, the pumps will stay on for 4 minutes.