Product Manual

100330-1 - 37 TON FULL BEAM LOG SPLITTER
ASSEMBLY
17
Engine
1. Place the engine on the engine mounting platform with the
recoil cover facing outward towards the wheel and align
the 4 holes on the engine base with the holes in the engine
platform.
2. Install a M10 × 45 bolt up through the hole on the engine
platform and through the hole on the engine base.
3. Place a washer on the M10 x 45 bolt and thread a M10 nylon
lock nut onto the bolt and tighten securely. Tighten to
11.8 lbf-ft − 14.7 lbf-ft (16-20 Nm) or fully, then ¼ turn
further.
4. Repeat steps 2 and 3 for the remaining bolts, washers and
lock nuts.
Suction Hose
5. Using the provided d32 hose clamps, connect one end of the
suction hose (50) to the port on the hydraulic oil tank (C) next
to the hydraulic filter and the other end to the pump inlet on
the side of the pump (D). Securely tighten the clamps on both
ends of the suction hose with either a flat head screw driver
or 8mm socket. Torque to 2.9 lbf-ft – 4.4 lbf-ft (4-6 Nm).
50
D
C
Oil Return (Low Pressure) Hose
6. Connect the loose end of the low pressure hydraulic hose (E)
to the to the tapered hydraulic fitting on the hydraulic fluid
filter (F). The low pressure hydraulic hose will only fit on this
fitting to ensure correct connection. Securely tighten the low
pressure hydraulic hose with a 27mm wrench. Tighten to
52 lbf-ft – 66 lbf-ft (71-90 Nm).
E
F
Oil Inlet (High Pressure) Hose
7. Place an O-ring into pump outlet fitting (A). Make sure the
O-ring is properly placed in the inner groove. Connect the
loose end of the high pressure hydraulic hose (B) to the pump
outlet (A). Securely tighten the high pressure hydraulic hose
with a 27mm wrench. Tighten to
44 lbf-ft – 52 lbf-ft (60-71 Nm).
A
B
7) Install the Log Catchers
Large Log Catcher (Engine Side)
1. With the log catcher angled upward, align the four holes
on the log catcher with the 4 threaded holes on the splitter
beam.
2. Place a M10 flat washers (22) and M10 lock washers (21)
onto the four M10 x 15 bolts (20) and thread them through
the holes on the log catcher and into the holes on the splitter
beam and tighten securely.
20
22
21