Replacement Part List

REV 76525-20140126 10
76525 ENGLISH
OPERATION
Pressure Washer Location
This pressure washer must have at least five feet of
clearance from combustible material. Leave at least
three feet of clearance on all sides of the pressure
washer to allow for adequate cooling, maintenance and
servicing. Place the pressure washer in a wellventilated
area. DO NOT place the pressure washer near vents
or intakes where exhaust fumes could be drawn into
occupied or confined spaces. Carefully consider wind and
air currents when positioning pressure washer.
Before Starting the Engine
1. Turn the water supply ON.
2. Pull the trigger on the pressure gun to purge all
air from the pump and hose. This may take several
minutes.
3. Do not start the engine until a steady stream of water
is flowing from the nozzle.
If the engine does not start after 2 pulls, relieve
pump pressure by pulling the trigger on the pressure
washer gun.
NOTE
If the engine starts but does not run make certain
that the pressure washer is on a flat, level surface.
The engine is equipped with a low oil sensor that will
prevent the engine from running when the oil level
falls below a critical threshold.
NOTE
Starting the Engine
1. Make certain the pressure washer is on a flat, level
surface.
2. Press the engine switch to “ON” position (Item A).
3. Rotate the fuel valve to the “ON” position (Item B).
4. Move the throttle lever (Item C) to the “Fast”
position.
5. Move the choke lever (Item D) to the “Choke”
position.
6. Pull the starter cord slowly until resistance is felt and
then pull rapidly. SEE NOTE.
7. As engine warms up, move the choke lever (Item D)
to “Run” and adjust the throttle as needed.
A
B
C
D
Keep choke lever in “Choke” position for 2 pulls
of the recoil starter. After second pull, move choke
lever to the “Run” position for up to the next 3
pulls of the recoil starter. Too much choke leads to
spark plug fouling/engine flooding due to the lack of
incoming air. This will cause the engine not to start.
NOTE
Starting the Engine Cont’d.
Distance from Cleaning Surface
The distance between the spray nozzle and the cleaning
surface is another factor that affects the impact force of
the water. The impact force of the water increases as the
nozzle is moved closer to the surface. You can vary the
impact force by controlling
1. The nozzle’s fan pattern.
2. The nozzle’s angle to the cleaning surface.
3. The nozzle’s distance from the cleaning surface.
Never use a narrow high impact stream on a surface that
is susceptible to damage. Avoid spraying windows with
a narrow high impact stream or turbo nozzle. Doing so
may break the glass.
1. Before triggering the gun, select a nozzle with a wide
fan pattern.
2. Place the nozzle approximately 4-5 feet away from
the cleaning surface. Then hold the nozzle at a 45
degree angle to the cleaning surface. Trigger the gun.
3. Vary the fan pattern spray angle and the distance
to the cleaning surface until optimum cleaning
efficiency is achieved without damaging the surface.
Never operate your pressure washer without water.
CAUTION