Installation Instructions Instruction Manual

INSTALLATION

Unpacking

1. Remove all packing from inside and on top of the machine.

2. Remove all packing from glass operated switch and left and right pick-up plates. Check

that the left and right hand pick-up plates are positioned properly.

3. Check the position of the splash curtains.

4. Check that the conveyor is aligned with the drive sprockets and the lift bracket on the right

hand side is firmly engaged over track adjusters.

5. Remove the packing from within and above the detergent tank.

6. Ensure the standpipe is in position in the detergent tank. Ensure the short standpipe is in

position on the right hand side of the wash tank underneath the conveyor lift bracket.

NOTE:

The wash tank standpipe is located inside the wash return screen for shipping.

7. Ensure that the wash return screen in the detergent tank is in position.

8. Check that the lower drain screen is in position.

INSTALLATION

PICK-UP

PLATE

MAIN TANK

STANDPIPE

SHUT-OFF

CURTAIN

DETERGENT

TANK

Figure 1 — Unpacking Parts

PAGE 1
INSTALLATION INSTALLATION Unpacking 1. Remove all packing from inside and on top of the machine. 2. Remove all packing from glass operated switch and left and right pick-up plates. Check that the left and right hand pick-up plates are positioned properly. 3. Check the position of the splash curtains. 4. Check that the conveyor is aligned with the drive sprockets and the lift bracket on the right hand side is firmly engaged over track adjusters. 5.
PAGE 2
INSTALLATION INSTALLATION (Cont’d) Measurements Uncrated Crated SW-400 SW-600 SW-400 SW-600 Height 38-1/2" (978) 38-1/2" (978) 49" (1244) 46-1/2" (1181) Width 48" (1219) 72" (1182) 25-1/4" (640) 27" (685) Depth 22" (559) 22" (559) 25-1/8" (638) 27-1/2" (698) Ship Wt. 225lb/102kg 285lb/129kg 154lb/70kg 176lb/80kg *adjustable foot height 1-3/4" (45) max.
PAGE 3
INSTALLATION INSTALLATION (Cont’d) Electrical Connections 1. The Glass Washer has a six foot power cord with a “U” ground tandem plug for connection to a power receptacle. 2. Provide a nonlocking 250 volt, 15 ampere, 2 pole, 3 wire grounding receptacle within four feet of the base of the Glass Washer(CSA TYPE 6-15R). This should be installed by a qualified electrician to meet the specifications of the local electrical code. 3. This machine operates from 208 to 240 volts.