Owner manual

32
  
 Section Assemby

Section Assemby
AssemblingtheConveyorBelt
1. Theconveyorbeltmayberolledupinthe
dishwasher.Ineithercasetheinstallationisthe
same.
2. Startattheunloadendofthemachineandpull
theconveyorbeltaroundtheendsprocketsuntil
approximately1-1/2feetofbeltrestsonthe
uppertrackofthedishwasher.
3. Pullasectionofbeltfromthenextsectionalong
theuppertrackintotheunloadend.
4. Jointhebeltsectionstogether
byfeedingaconveyorrodthroughthelinks,
spacers,androllers.Installacotterpinoneach
endoftherodtosecuretheassembly.
Refertoanassembledrodsectiononthebeltfor
partsarrangement.
5. Continuethisprocedureuntiltheconveyorbeltis
acompleteloop.
6. Thetake-upassembliesarelocatedoneither
sideoftheloadendconveyorshaft.
7. Adjusttheconveyorbelttensionattheloadend.
Loosentheadjustingboltlocknutsthenturnthe
adjustingboltsCWtotightenthebelt.
8. Makesurethebelttensionisevenonbothsides.
9. Checktheslackofthelowerportionofthebelt.
Thelowerbeltmustnotsag.Continuetoadjust
belttensionasyoumanuallyremovelowerbelt
slackuntil
thelowerslackisminimized.
10. Checkthebelttensionbyliftingtheupper
conveyorbeltattheunloadend.
11. Adjusttheclutchassemblywhenthebeltis
adjusted.
12. Tightentheadjustingboltlocknutsoneachtake-
upassemblytoholdthebelttensionadjustment.