User's Manual

Chapter 2. Operating the Scanner
2.1 Getting Started
The barcode scanner provides the easy-use control buttons and easy-read
signal for user scanning experience. The following will give a guide to start with
this scanner.
2.1.1 Attach Neck Strap
It is recommended to attach the neck strap to the barcode scanner and
wearing it on either neck or hand for a convenient and safety carry.
2.1.2 Charge Battery
The barcode scanner is installed with a high capacity Lithium battery.
When the LED shows flashing red, it indicates low battery and the
capacity is less than 30%. It needs to be charged.
The barcode scanner can be charged by either PC USB port or adaptor.
To charge the scanner, connect the USB port between PC USB port or
adaptor. When the battery is fully charged, the LED illuminates green.
Remove the USB cable from PC USB or adaptor.
2.2 Power up Scanner
To power up the scanner, press “UP” button. The scanner is ready for
scanning barcodes.
2.3 Reading Barcodes
The scanner supports all major 1D barcodes. To read the barcodes, press the