Quick start manual

www.chamsys.co.uk MagicQ Software Quick Start
35 of 44
• Click on the top part of the X grey encoder wheel to increase the value of the encoder and to select different gobos
– click on the bottom part of the wheel to decrease the value.
• It is also possible to click in the window with the legend for the encoder – clicking below the gobo icon moves to
the next gobo on the gobo wheel. Clicking above the icon moves the previous gobo.
• Click and hold on the gobo icon to see a list of all the different gobos – pick one from the list.
• Now open the Outputs Window by pressing the OUT button.
• The Outputs Window shows parameters that are in the Programmer in red. Note that the Mac 250s are at 100%
intensity.
• Press the CLEAR button to clear the programmer and notice that the Outputs Window now shows the Mac 250s at
0%.