User manual

ChamSys Ltd www.chamsys.co.uk
MagicQ User Manual 88 Version 1.3.0.0
sets head 5 to 100% intensity and adds head 5 to the current selection
13.5.7 Select heads in Col, Beam, Pos
This option enables you to select heads by typing the head selection and then pressing the appropriate
Colour, Beam or Position Window button.
1 THRU 4 COL
selects heads 1 through 4 and opens the Colour Window.
13.5.8 Select heads on include
This option determines whether when you include Cues and Palette entries into the programmer the
console automatically selects the heads.
If enabled, the console selects all heads that have levels in the Cue or Palette entry.
13.5.9 Highlight defaults beam and col
This option determines which highlight mode is used by the console.
When enabled, highlight mode sets all currently selected fixtures to 100% intensity and default beam
and colour settings.
When disabled, highlight mode simply reduces all non selected fixtures in the programmer to 0%
intensity.
13.5.10 Select Multiple Groups
Setting the "Select Multiple Groups" option in the Setup Window changes behaviour so that multiple
groups can be selected without pressing SHIFT. To deselect all groups press the DESELECT ALL soft
button in the Group Window.
13.5.11 Enable undo
This option enables undo of programmer changes. The ASSIGN button has been changed to be the UNDO
button. Assign functions are now available using the MOVE and COPY buttons.
Pressing SHIFT and UNDO redoes the last change.
13.5.12 Swap Encoders
The Pan and Tilt encoders can be swapped over as can the direction of all encoders.