Operator`s manual

BLOWING OPERATION
T
9
his Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
ARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
W
CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
e blowing port on the back side of the power head and screw into
5. Fit the desired extension wand and / or nozzle to the vacuum hose. (fig. 3)
rd into the outlet. (fig.4, fig.5)
ARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE PLUG IS
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the large end of the hose into th
position. (fig.2)
6. Verify that the switch is in the ‘O’ OFF position before plugging the power co
7. Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the ‘I’ ON position. (fig.6)
MAINTENANCE
W
DISCONNECTED BEFORE CHANGING AND CLEANING FILTERS.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
r clockwise direction. (fig.2)
they have not been damaged.
USE
e
2. Disconnect the hose from the vacuum, turning large end in counte
3. Undo the latches and remove the power head from the container. (fig.3)
4. Clear all dirt or debris from the container and hose. (fig.4)
5. Check the hose, attachments, and power cord to verify that
IMPORTANT! Clean or change the cartridge filter regularly for best performance. ALWAYS
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used with out the cartridge filter, th
motor will burn out and the warranty will be voided. Always keep spare filters on-hand.