User's Manual

6. Once the synchronization has occurred, the indoor rain monitor will detect
updated rainfall information from the transmitter every minute
automatically.
7. If the antenna wave icon does not appear on the display after the 6 minutes
synchronization period, it means synchronization has failed.
8. Indoor rain monitor will start synchronization again after 2 minutes until
synchronization successful.
During the synchronization period, press any key to stop the synchronization
procedure.
Rainfall Alert Mode description
- To activate the rain alert mode, slide the Alarm switch to the “On”
position. A beep alarm will sound for 10 seconds when the rain mode is
changing.
- Rain mode alert description:
o No Rain: Take an average of the rainfall less than 0.02IN/0.05MM on
the past few minutes
o Light Rain: Take an average of the rainfall between 0.02IN/0.5MM to
0.18IN/4.6MM on the past few minutes
o Heavy rain: Take an average of the rainfall equal or over 0.2IN/5.1MM
on the past few minutes
- To turn off an alert mode, slide an Alarm switch to “Off” position.
Date Transmission
• No Rain - If the latest rain mode was "No rain" and keep a "No rain" mode
condition on the past 5 minutes.
•
Light Rain - If the latest rain mode was "Light rain" and keep a "Light rain"
mode condition on the past 3 minutes.
•
Heavy Rain - If the latest rain mode was "Heavy rain" and keep a "Heavy rain"
mode condition on the past one minute.
Low battery indicator and battery changing
If you see that the low battery indicator(s) has changed to half-full status,
please install the fresh batteries as follows:
Indoor rain monitor
Remove the old batteries from the battery compartment and insert 2 fresh “AA”
alkaline batteries. Unit will sync with the outdoor transmitter unit
automatically.
NOTE: After battery replacement, if you find any data show on the indoor rain
monitor display, it must an acuminated data, please press the “RESET” button for
1 second to clear the display and start from 00.00IN or 000.0MM counting.
Outdoor rain gauge
To change the outdoor rain gauge batteries, you must press and holding the
“RESET” button for 5 seconds on the indoor rain monitor and let it re-sync again.
NOTE: After battery replacement, if you find any data show on the indoor rain
monitor display, it may a wrong counting during battery changing, please press
the “RESET” button for 1 second to clear the display and start from 00.00IN or
000.0MM counting.
“ERR” signal occurred on rain monitor display
When the indoor rain monitor notes an accumulative data out of the display range
(Maximum inch data is 99.90IN and millimeter data is 999.9MM), the unit will show
“ERR” signal on the display and sound for 1 minute. Press any key to clear “ERR”
signal and start from 00.00IN or 000.0MM counting.
Resetting the outdoor rain gauge and troubleshooting