User's Manual

2
Repeater Setup
Install or Replace Batteries
AcuRite recommends high quality
alkaline or lithium batteries in
the repeater for the best product
performance. Heavy duty or
rechargeable batteries are not
recommended.
The repeater requires lithium
batteries in low temperature
conditions. Cold temperatures can
cause alkaline batteries to function
improperly. Use lithium batteries in
the repeater for temperatures below
-4ºF / -20ºC.
1. Slide off the battery compartment
cover.
2. Insert 6 x AA batteries into the
battery compartment, as shown.
Follow the polarity (+/-) diagram
in the battery compartment.
3. Replace the battery cover.
NOTE: When batteries need to
be changed, replace the upper 3
batteries before replacing the lower
3 batteries to avoid interrupting
signal transmission.
SETUP
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to
be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries
in re, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
Install Batteries
6 AA batteries