User`s manual

4
The environment and personal safety must be considered when disposing of this appliance.
Please ensure the appliance is taken to a recycle center for safe recycling. DO NOT dispose
of the appliance in land fill as the insulation and refrigerant gas contained in these
appliances are flammable.
Warning:
1. Keep ventilation openings in the appliance enclosure or in the structure for building in
clear of obstruction.
2. Do not damage the refrigerant circuit.
3. Do not use electrical appliances inside the food storage of the appliance unless they are
of the type recommended by the manufacturer.
• Transportation and Handing
When transporting, hold the base and lift the refrigerator carefully with the angle more than
45 degree. Never hold the door handle as support. Never place it upside down horizontal
wise.
• Installation
1. Install the refrigerator at a place with a flat, firm ground directly to prevent vibration and
noise.
2. Choose a well-ventilated place. A space of no less than 10cm must be left around the
refrigerator. Especially for the back of the fridge, it should be no less than 13cm space to
wall.
3. Choose a location where there is no heat source. Keep the refrigerator away from direct
sunlight and oven etc.
4. Choose a dry and well-ventilated place where there is no corrosive air.
• Testing
1. Clean the parts of the refrigerator with lukewarm water containing a little neutral detergent
and with clear water, and wipe them dry.
Notes: Electric parts of the refrigerator can only be wiped by dry cloth.
2. Turn the thermostat knob to the "3" position, turn on electricity. The compressor and the
light inside the refrigerator begin to work.
3. Open the door 30 minutes later, if the temperature in the refrigerator decreased obviously,
it shows that the refrigerator system works well. When the refrigerator operates for a period
of time, the temperature controller will automatically set the temperature within limits it