User's Manual

FAST OPERATION MANUL EA2000T
stands that it received the data from PC.
· When the Data LED light, it stands receiving data from keypad
USB
CONNECTION
· Toggle the connection switch to the USB position
· Connect the base station with PC USB port,the Status LED will flash every half
second if connection is successful.
· The Status LED will flash quickly after the software and base station communicate
normally.
· Initial installation, PC will automatically remind that have found new device and
install the drive automatically.
TCP/IP
CONNECTION
· Toggle the connection switch to the NET position
· External power connects the DC adapter provided by us, the Power LED light.
· Insert the standard network cable into the network port, connect the base station and
the network hub, meanwhile, and connect the PC and the network hub.
· Please notify that only software is set the correct TCPIP address, and then
connection can be assured successfully.
RADIO
CHANNEL SET
· After logging in application software, choose the new channel in the “channel” of
“base station set”, then click “set”.
· When using the multiple base station solution, the frequency channel of each base
station should be different, and it’s better not to set the neighboring channel
· Only when frequency channel is interfered or communication is not good, then you
need to consider changing and resetting the channel, usually you needn’t.
BASE STATION
TEST
After connetion is ok, power on keypads, then do keypads testing.
FCC Caution.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn