User's Manual

Do not operate remove control craft in the

following situations.

■ If others a operating RC craft near by

■ In cities or populated areas.

■Near airports or hospitals or any take of and landing

point or real aircraft.

■In places prohibited by law to operate RC craft.

Do not stand the radio upright when setting up your model

■ The radio may fall over causing unwanted switches

Ensure to check all flight control surfaces working

Correctly before flight.

■Any control surfaces jammed or not working

Correctly may cause crash.

Ensure the throttle is in the lowest position and all

Control switches are in the correct position before

Powering the models receiver.

Do not touch engines or electric motors after use. These

items may be hot and cause burns or injuries.

Keep the model in sight while flying. Do not behind trees

or buildings. Doing so may cause loss of signal and loss

of model or damage to property or people.

Ensure you have setup fail safe with your receiver. Set the

throttle to lowest position in failsafe situation. Refer to the

manual of your receiver for fail safe.

Ensure to return the model screen to the main page.

■ Leaving the radio open in a menu screen while

flying may cause unwanted changes of settings.

Be sure to check the remaining battery power of the

transmitter receiver before flying.

Too little remaining power can cause a crash.

When making adjustments on the controller shut the

models engine first. Ensure safety is taken not to start

the throttle and cause unexpected rotation of engine

or motor.

Do not leave device or batteries in hot locations such as

cars or direct sunlight.

Do not cover batteries while charging. Do not leave the

battery in direct sunlight, in a hot weather

Do not use old or damaged batteries

Do not allow the device to get wet or operate the device in

wet conditions.

Do not dispose of batteries in fire

INTRODUCTION