Operating instructions

6
8. Synchronization
Press the SYNC key on the front panel or 00 DOWN from the handheld. A counterclockwise move-
ment is performed to synchronize the control unit with the drive unit for proper operation.
Synchronization takes slightly over one minute.
After severe storms, or an extended period of use, the rotator may appear to position the antenna
incorrectly. First try pressing the SYNC key to re-synchronize the system. If this fails, the antenna or
drive motor may be misaligned on the mast. You may either go to the antenna and re-orient it, or
reprogram the control unit to correspond to the new antenna orientation.
9. Auto Synchronization
The unit may be set to program a sync command automatically after 50 preprogrammed moves.This
feature is switched on (or reset to 50) by pressing 98 UP. It is switched off by pressing 98 DOWN.
Check to see if active by pressing 99 UP (Display Status) and observing “SYn on” or “SYn OFF”.
10. Timeout
The unit may be set to switch off after 8 minutes of no activity by pressing 97 UP. This feature is
deactivated by pressing 97 DOWN. Check to see if Timeout is active by pressing 99 UP (Display
Status) and observing “to on” or “to OFF”. The unit automatically switches off 5 seconds after it is
initially plugged in or after a power glitch.
Using the controller with a “Universal Remote Control”
Universal handheld remote controls are popular as they can typically control a TV, a VCR, a cable box
and audio components. They are also cheap and ideal replacements for lost and broken units. The
rotator controller will respond to commands from universal remote controls configured to control most
Pioneer
®
brand cable converter boxes (HH1 mode) or most Pioneer
®
brand CD players (HH2 mode).
See Appendix A. Refer to the instructions supplied with the universal remote control. Note: Channel
Master cannot guarantee universal handheld remote control compatibility.
Appendix A
Front Panel Setup Summary
SET 60 Hz POWER
▲ + ▼ AT POWER UP
SET 50 Hz POWER ▲ + ▼ + SY AT POWER UP
SET REMOTE HH1 ▲ + SY AT POWER UP
SET REMOTE HH2 ▼ + SY AT POWER UP
Example: To set for 60 Hz power:
a. Disconnect the power connector at the rear of the unit.
b. Press and hold UP and DOWN in together.
c. Reconnect the power connector at the rear end of the unit.
d. Release UP and DOWN
Other functions are set in a similar manner using the following buttons at b and d:
50 Hz POWER: UP, DOWN, and SYNC
Remote handheld 1 (supplied unit and most Pioneer
®
cable boxes): UP and SYNC
Remote handheld 2 (most Pioneer
®
CD players): DOWN and SYNC
Check settings are correct by removing power for a few seconds, then reconnect power.
Display will indicate:
60H (or 50H for 50 Hz)
HH1 (or HH2 for alternate remote)