User`s manual

DESCRIPTION : COMPONENTS
1
02.9698.0002 0 13 December 2012 7
Luminaire Overview
The following illustration shows the external luminaire components and controls.
Figure 1-2: External Components and Controls
ENTER
MENU
DATA THRU
DATA IN
~
AC IN
AC Input
Data In Data Thru
Product Label ID
Head Assembly
Input Panel
Menu Display
Provides DMX In and Thru,
and AC Power connections.
Used to input manual
commands, program, test,
set defaults and access
Houses Master Control
Houses CMY color, gobo,
strobe, prism, frost, zoom lens and iris
Yoke Assembly
Backcap Assembly
Provides access to lamp
for replacement and
provides controls for
internal status information.
beam adjustment.
(see detail below)
Upper Enclosure Assembly
Houses power supply, ballast,
and display board.
CAUTION:
RISK OF EXPOSURE TO EXCESSIVE ULTRAVIOLET RADIATION. DO NOT OPERATE
WITHOUT COMPLETE LAMP ENCLOSURE IN PLACE OR WHEN LENS IS DAMAGED.
ATTENTION:
RISQUE D'INCENDIE. UTILISER UNIQUEMENT UNE LAMPA HALOGENE EN METAL DE
TYPE H, 1500 WATT, 100V ET UN SUPPORT SFc10-4.
CAUTION:
RISK OF FIRE. USE ONLY 1500 WATT, H TYPE 100V METAL HALIDE LAMP,
SFc10-4 BASE.
DISCONNECT FIXTURE
BEFORE RELAMPING
CAUTION:
HOT LAMP
DO NOT OPEN FOR 5 MINUTES
AFTER SWITCHING OFF.
X
YZ
Beam Adjustment Controls
Input Panel Components
Board (MCB).
mechanisms.
Note: Truss hooks, clamps,
Mounting Brackets
etc. are sold separately.