User`s manual

VARI❋LITE VL3015LT SPOT LUMINAIRE USER’S MANUAL
64 13 December 2012 02.9698.0002 0
Gobo Replacement - Gobo Wheels
Tools:
#2 Phillips screwdriver
WARNING: Remove power from luminaire before performing maintenance. Gobos may be HOT
after operation. Allow to cool before replacing.
To replace a rotating gobo:
Step 1. Remove power from luminaire.
Step 2. Remove top and/or bottom head cover by loosening four 1/4-turn screws to access the three
gobos wheels.
Step 3. If removing gobos via bottom of head assembly, undo fan tray assembly with thumb screw
to access.
Step 4. Rotate desired gobo wheel until required gobo position is accessible.
CAUTION: Do not push on gobo glass. Press on gobo carrier only.
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other covering while
replacing. To clean, refer to “Cleaning Optics, Filters and Gobos” on page 68.
Step 5. Remove current gobo by carefully pressing on edges of gobo carrier with fingers, pressing
gobo toward front end of luminaire (toward lens), and out of wheel.
Step 6. Install new gobo as follows:
a. Align three tabs on gobo carrier with three notches in wheel (gobo can only be oriented
in one direction).
b. Insert gobo carrier into wheel, ensuring that carrier snaps into place.
Step 7. Replace cover(s).