Installation manual

+"
The basic operation of the SVS-88 supports four IR commands (additional IR
commands described in the Advanced Operation section of the manual), Input
UP and Down, as well as Volume Up and Down. These commands are
specific
to the output
for which they are programmed. For example, you can have one IR
learning remote in the theater (let’s say Output number 3) and a different
learning remote in the bedroom (Output number 7). Each remote will enable you
to scan through the installed inputs as well as adjust the volume independently
from one another.
Programming IR Learning Remote
To program your IR learning remote, you must first select the IR teaching
command from the front panel keypad of the SVS-88. To do this press “FUNC”
(Function), “FC” will appear on the display. Next, input the number “44” and "Enter".
The display will read “tE” (Infrared Teach Mode) and the current output number.
Press - FUNC 4 4 ENTER
Using the “Output -/+”, select the output you wish to program with an IR
command. Place your Learning Infrared Remote into program mode (refer to
your IR remote for details on how to accomplish this). Place the IR receive LED
approximately 1 to 2 inches from the IR emitter on the front panel. Select one of
the four buttons you wish to program to that output, “Input -/+” or “Volume
-/+". Each time one of these buttons is pressed, the IR command associated
to that button is broadcasted out of the IR teaching window located on the SVS-88
front panel.
This process may be repeated as many times as necessary until all of the
required commands have been learned.
Theater Remote
Press - OUTPUT + (until output 03 is displayed) -
Place learning remote's IR receiver in front of the IR teaching window and press
"INPUT +" (the command for “Input has been broadcast to the learning
IR remote).
Note: If no command is selected within a few minutes, the SVS-88 will automatically
exit the Infrared Teach Mode and return to displaying an Output with its associated
Input.
Once you have completed the process of teaching your IR learning remote the
desired IR commands, you can exit the IR teaching mode on the SVS-88. To do this
press “FUNC” (Function), “FC” will appear on the display. Next, input the number “46”
followed by “Enter”. The display will show the last used input and output.
.
Example:
Example:
Example:
Press - FUNC 4 6 ENTER
9