Installation manual

RS-232 Commands
Controlling the SVS-88 via the RS-232 port is done using a text based command
set (ASCII). The response from the SVS-88 either as a response or on power-up
is also text based. The commands and their associated responses can be
programmed into any control system (i.e. Crestron, AMX, etc.) If you would like to
setup or change the operational characteristics of the SVS-88 and you are not
using a control system, any terminal program can be used; One is available free of
charge on our web site www.ChannelPlus.com.
On power-up the SVS-88 will output the current operational settings of the unit.
Any time the unit has power removed and reapplied, the current operational
settings will be listed. The following is the default for the SVS-88. If any settings
are changed during operation, they will be reflected in the data.
NOTE: All messages sent to the SVS-88 and received by the SVS-88 end with
a carriage return (ASCII 0D). This will not be reflected in the examples. In
addition, all messages sent to the SVS-88 are case sensitive.
The response from the SVS-88 on power-up:
MXxx-Model No. = SVS-88
MXxx-Serial No. = 0A000004
MXxx-Video=08 to 08
MXxx-Video=07 to 07
MXxx-Video=06 to 06
MXxx-Video=05 to 05
MXxx-Video=04 to 04
MXxx-Video=03 to 03
MXxx-Video=02 to 02
MXxx-Video=01 to 01
MXxx-Audio=08 to 08
MXxx-Audio=07 to 07
MXxx-Audio=06 to 06
MXxx-Audio=05 to 05
MXxx-Audio=04 to 04
MXxx-Audio=03 to 03
MXxx-Audio=02 to 02
MXxx-Audio=01 to 01
MXxx-Volume 08 to 32
MXxx-Volume 07 to 32
MXxx-Volume 06 to 32
MXxx-Volume 05 to 32
MXxx-Volume 04 to 32
MXxx-Volume 03 to 32
MXxx-Volume 02 to 32
MXxx-Volume 01 to 32
MXxx-Sensitivity 08 set to 32
MXxx-Sensitivity 07 set to 32
MXxx-Sensitivity 06 set to 32
MXxx-Sensitivity 05 set to 32
MXxx-Sensitivity 04 set to 32
MXxx-Sensitivity 03 set to 32
MXxx-Sensitivity 02 set to 32
MXxx-Sensitivity 01 set to 32
MXxx-Balance 08 set to 49
12