Installation manual

Front Panel Commands
As the individual digits are entered for each command, they will be displayed on
the front panel. As the second set of numbers are input, the command number will
move from one set of displays on the right to the other displays on the left, and
remain there until the “ENTER” button is pressed. The SVS-88 Unit Number will
not be seen while the command data is being entered. Again, the command will be
sent to the learning remote as soon as the “ENTER” key is pressed.
Example:
Teaching Front Panel Button 5
Press - 0 5 for front panel button number 5 (tE - 05 is displayed).
Press - 0 0 for all outputs (05 - 00 is displayed).
Press - 0 0 for required data entry as no input is necessary (05 - 00 is
displayed).
Place the learning remote's IR receiver in front of the IR teaching window and
select the new associated “Front Panel Button 5” button on the IR learning remote.
Press - ENTER (the command for “Front Panel Button 5” has been broadcast
to the learning IR remote).
The following list is the available learnable IR commands on the SVS-88.
yy = 00 = front panel zero button
01 = front panel one button
02 = front panel two button
03 = front panel three button
04 = front panel four button
05 = front panel five button
06 = front panel six button
07 = front panel seven button
08 = front panel eight button
09 = front panel nine button
10 = front panel A/V button
11 = front panel Audio button
12 = front panel Video button
13 = front panel Off button
14 = front panel Function button
15 = front panel Preset button
16 = front panel Enter button
17 = front panel Cancel button
18 = front panel Input button –
19 = front panel Input button +
20 = front panel Output button –
21 = front panel Output button +
22 = front panel Volume button –
23 = front panel Volume button +
43