Installation manual

Output Commands

These commands are output specific and must include the output number.

Example:

Teaching Mute for Output 3

Press - 3 9 for mute/unmute (tE - 39 is displayed).

Press - 0 3 for output number 3, 00 cannot be used as these commands are

zone specific (39 - 00 is displayed).

Press - 0 0 for required data entry as no input is necessary (39 - 00 is

displayed).

Place the learning remote's IR receiver in front of the IR teaching window and

select the new associated “Mute Output 3” button on the IR learning remote.

Press - ENTER (the command for “Mute Output 3” has been broadcast to the

learning IR remote).

24 = output Volume down

25 = output Volume up

39 = output Mute/Unmute (toggle)

A/V Commands

Example:

Teaching Route A/V Input 2 to Output 5

Press - 3 6 for zone A/V input selection (tE - 36 is displayed).

Press - 0 5 for output number 5, 00 cannot be used as these commands are

zone specific (36 - 05 is displayed).

Press - 0 2 for Input number 2 (36 - 02 is displayed).

Place the learning remote's IR receiver in front of the IR teaching window and

select the new associated “Route A/V Input 2 to Output 5” button on the IR learning

remote.

Press - ENTER (the command for “Route A/V Input 2 to Output 5” has been

broadcast to the learning IR remote).

36 = zone A/V input selection

37 = zone audio input selection

38 = zone video input selection

39 = zone digital input selection