Installation manual

Presets
Programming Presets from the Keypad
Presets are useful for setting the system for predefined configurations (i.e. theater
DVD, family room theater, etc.) Presets can both be programmed and executed
from the front panel. The SVS-88 can hold a total of 16 presets. When
programming a preset from the front panel, the SVS-88 takes and saves a
snapshot of the configuration of the unit at that moment. The snapshot includes
audio, digital and video routes as well as the volume for each output. To make
specific modifications to a preset, you must use the appropriate serial commands
previously discussed.
To program a preset, you must first select the preset programming mode from the
front panel keypad of the SVS-88. To do this, press “FUNC” (Function), “FC” will
appear on the display. Next, input the number “47” followed by “Enter”. The display
will read “PE” (Preset Programming Mode).
Example: FUNC 4 7 ENTER
Next, select a preset number (01 – 16) followed by “Enter”. Make sure you take
note of the configuration programmed for each preset. Once “Enter” is pressed,
the current settings for the SVS-88 will be assigned to that preset number.
Example: 01 ENTER
Executing Presets from the Keypad
To execute a preset from the front panel, you must select the preset mode from the
front panel keypad of the SVS-88. To do this press “PRESET”, “PE” will appear on
the display. Next, input the preset number to execute followed by “Enter”. The
display will read “PE” (Preset Selection Mode). In the following example, preset
number 01 will be executed once the input key is pressed.
Example: PRESET 01 ENTER
47