Installation manual

There are no user serviceable parts inside. Refer all servicing to
qualified service personnel.
WARNING:
WARNING:
To reduce risk of fire or electric shock, do not expose the SVS-88 to
extreme heat, extreme cold, moisture or water. This apparatus should
not be used near water - for example, near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement, or near a swimming pool,
etc. Do not allow foreign objects to get into the enclosure. If the unit
is exposed to moisture, or a foreign object gets into the enclosure,
immediately disconnect the power cord from the wall. Take the unit to
a qualified service person for inspection and the necessary repairs.
The SVS-88 operates off power sources 100 to 240 VAC. It may also be operated at 50/60 Hz
line frequency. The unit is autosensing for power configuration.
The appliance should be situated so that its location or position does not interfere with its proper
ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar
surface, that may block the ventilation openings; or placed in a built-in installation, such as a
bookcase or cabinet that may impede the flow of air through the ventilation openings.
Care should be taken so that objects do not fall into and liquids are not spilled into the inside of
the appliance.
The SVS-88 is designed for set top usage only. The SVS-88 must be placed on a fixed, level
surface strong enough to support its weight.
Connect the SVS-88 to the power outlet only with the supplied 3-prong grounded power
supply cord or an exact equivalent. The cable should be connected to a properly grounded
3-conductor wall outlet. Do not modify the supplied cable in any way. Extension cords must
be rated for adequate current. Power cord for countries other than North America not included.
Do not route the power cord where it can be crushed, pinched, bent at severe angles,
exposed to heat, or damaged in any way. If the cord shows any sign of wear or damage,
immediately stop using it and obtain a proper replacement from a qualified service agency or
from the Linear service department.
If the SVS-88 shows signs of improper operation, or if it has been dropped or damaged in
any way, immediately disconnect the power cord from the power outlet. Contact the Linear
technical service department and speak to a qualified service technician to determine if
the unit needs to be returned to Linear for repair. See the back of this manual for futher
information regarding returning SVS-88 units.
3
3