Specifications

109

7.0 Configuring Cisco Router

Do this after you insert the touch screen and IPs.

Now you need to setup the Cisco 831 for internet access and DHCP.

http://192.168.130.90/admin/

Go to setup and Cisco and generate the Cisco configuration and do the on screen instructions.

Make sure it takes the Cry key gen rsa line at the very end. It will only go through when you have

internet access. You have two options, wait for internet access or add a line to the config ‘ip domain-

name insightbb.com’.

If it does not work, try restarting the cable router, then the 831 router. The 831 takes a while to boot

up. Once it boots up you should get a 192.168.100.1 or 10.X.X.X. Setup DHCP and go to

74.128.1.122 and you need to go through the screens. Once you go through, you must restart 831.

Then it should work.

Once you have internet service, reboot the server and let it install updates if any.

We recommend using a Cisco Router or a SonicWall when setting up your router. If a standard router

is being used instead, port forwarding will need to be used. Refer to the Technician Manual for

more details about this subject.

Important: If a Cisco or SonicWall is not used, you will not be able to access your system using the

unique URL through your local network. It will only be accessible from outside the home. To gain

access from inside your home, you need to use the IP Address http://192.168.130.90/website/admin/

or https://192.168.130.90/admin/

that was mentioned earlier in the Accessing the EyeOn Home

Administrator Screen. Using the internal IP on the local network will cause the system to have

limited functionality (see About Limited Functionality below). If a Cisco router is being used, please

refer to the EyeOn Technician Manual for setup instructions.

Note: If the local network has a DNS server the Cisco router or SonicWall will not be necessary. When

the system is connected to the internet it will use a Dynamic DNS server to update the URL and IP

address.

If you would like to access SSH to the EyeOn server use port 22. If you would like to access the Cisco

Router to the EyeOn server use port 2001.

7.1 Limited Functionality

If you must use the private IP (192.168.130.90) to access your EyeOn User System from inside your

house, you will have limited functionality. The following limitations will only occur with the

Surveillance System and SSL certificate:

• You will see a security warning stating that your SSL Certificate is not valid. This does not

mean that your site is not secure; it just means the name does not match the internal IP address.

This warning will not cause your system to run incorrectly.