Specifications

127
2. Code Read Back
* This function will indicate code number which you selected.
• Press and hold [Device] + [Info] buttons until the LED illuminates.
• Release the buttons pressed in step [1].
• Then LED will blink 3 times every 1seconds.
• First blinking LED indicates 100 digit of selected code.
• Second blinking LED indicate 10 digit of selected code
• Third blinking LED indicates 1 digit of selected code.
• Fast blinking means digit “0”.
Example: If selected code number is “1 0 8 “, then LED will blink
[One time], [1second pause], [Fast blink], [1second pause], [8 blinks].
* If a code is found through the Auto scan method, this function can be used to document the selected
code.
3. Learning Function
This function is for the learning and storing IR codes which are not supported in the standard
universal library. The Hitcents remote and user remote should be held 1” from the IR LED at the front
of the remote.
All buttons on the user remote should be pressed two times for learning each code into memory.
1) Learning sequence: This step is for memory data from the user’s remote to Hitcents remote control.
• Press and hold [Device] and [Rec] button simultaneously for 3 seconds until LED illuminates.
• Press button on the Hitcents remote to be store learned code and the LED will blink one time.
• Press and release the button on the user remote to be learned. The Hitcents remote LED will
blink slowly once.
• Press and release the button on the user remote to be learned. The LED will blink twice.
• To learn another button repeat steps 1-2 to 1-4 or press any [Device] button to exit learning
mode.
Example: If you want to learn the VOLUME UP code to Hitcents remote TV volume up button.
1. Press and hold [TV] and [Rec] for 3 seconds until LED illuminates.
2. Press volume up button on Hitcents remote control.
3. Press volume up button on User’s remote control. -> Blink Slowly Once
4. Press volume up button on User’s remote control -> Blink Twice
5. Press TV:
* During the learning process, the LED Hitcents remote may blink very quickly. This means the
transmitting signal is not in a valid range or the button was held down too long. If this situation occurs,
please adjust the remote’s angle, reduce/increase remote distance or try pressing the button faster.
2) Clear Learned Device: This function will clear All learned data on a selected device.
• Press and hold [Device] and [Exit] buttons for 3 seconds until LED illuminates.
• Press [All] Button.
3) Clear Learned Button: This function will clear a specific learned button on a specific device.
• Press and hold [Device] and [Exit] buttons until LED illuminates.
• Press the specific button to delete an existing learned code.
• To delete other buttons Repeat 3-2 or press any [Device] button to exit this mode.