Specifications

4.4 AUDIO: Integra DPC 8.5 (030001)

There is no software to communicate with the Integra DPC-8.5, six-disk DVD player. All that is needed

for the EyeOn system to communicate with this device is to plug it into the server with a RS232 cord.

If you are using any of the supplied Nuvo keypads, you must program in the IR commands to give the

keypad the ability to start, stop, skip, etc.

To view the DPC-8.5 Owner's manual use your EyeOn Technician CD to view the file DPC85.

4.4.1 IR Setup from Nuvo Keypad control

Again if you are not using any of the Nuvo keypads you do not need to do this. The touch screen will

control this device with the RS232 commands. If you are using Nuvo keypads, you can grab the

Integra IR file off of the CD and put it into your Concerto IR Library (c:\program

files\Nuvo\Concerto\Library) Then you must delete the source for the CD player and add it again.

Setup all the macros. Make sure you have an IR cable from the Concerto and the CD Play IR In.

Test!

If this is a new CD player you need to use the Nuvo Concerto software to add these IR commands

into the system. You will have to have a Nuvo Concerto IR Learning Station to perform the following

steps.

Plug rs232 from learning kit to laptop. Make new device and model. Keep default on IR code. Learn

in each code. Then go back to Concerto and delete the source if it is already added. Then add the

source and setup the macros. Make sure you have an IR cable from the Concerto and the CD Play

IR In. Test!

For advanced diagnostics you can view file Integra DPC 8-5 RS232 on your EyeOn Technician CD

to get a list of the RS232 protocols. This device connects at 9600 BPS 8-N-1.

In the past we have had many DPC DVD players start to skip, pause on their own, etc. This is not

caused by IR or RS232 commands. This is a problem with the DVD player. Send back DVD player

for new one.

4.4.2 Resetting DVD player

Try resetting the unit by holding down the stop button on the player (not the remote) and the

standby/on button at the same time. The display should read INITIALIZE and when it’s done it will

read COMPLETE.

4.4.3 EyeOn Remote IR Code

The DVD IR code for the EyeOn remote is 025. Look at the remote setup for more information