Specifications

4.10 SECURITY: ELK M-1 (050001)

Hooking up the Elk security system is the most in-depth part of the EyeOn installation process. The

Elk controls the in-house security system, opening and closing garage doors, turning touch screens

on and off, routing power to different devises, intercom systems, pool alarm, etc.

The following files can be found on your EyeOn Technician CD.

For the ELK M-1 installation and programming manual view file

M1_Installation&Programming_Manual.

For the ELK user guide view file M1_User_Guide.

For the ELK M1DBH data Bus Hub installation guide view file M1DBH_Data_Bus_Hub.

For the ELK M1TWI Two Way Listen-in Interface installation guide view file M1TWI_2_Way_Interface.

For the ELK M1 LCD Keypad installation manual view file M1KP_LCD_Keypad.

For the ELK M1RB Output Relay Board installation guide view file M1RB_Relay_Board.

For the ELK M1XOVR Output and Relay Expander installation guide view file

M1XOVR_Output&Relay_Expander.

For the ELK M1XIN 16 Zone Expander installation guide view file M1XIN_Input_Expander.

The first part of the Elk configuration will be installing all the input and output devices. For this step of

the process you will have to use the ELKRP M1 SOFTWARE 1.6.10. Use your EyeOn Technician CD

to download the full version, file ElkRP_Full_Install_1_6_10. You will have to plug your computer

directly into the ELK onboard serial port. Or you can enroll these cards through the ELK keypad itself.

After you have installed the software you will need to setup the com port. Go to connections then

select com port. You will probably use com port 1. After that, select IPconf line. Hit okay and create a

new account (Image below).