Specifications

37
After you have setup the Area's you will need to setup the keypads used in the house. Before setting
up the keypads you will have to enroll them into the system. Each keypad will have an assigned
address. From the factory all keypads are set to address one. Valid keypad addresses are 1 to 16.
The first keypad on the system (Keypad 1) is automatically enrolled upon power up. Each additional
keypad must be assigned a unique address and then manually enrolled from Menu 1 - Bus Module
Enrollment.
(This only has to be done if there are more than 1 keypad)
1) Press and hold the * key, followed by the F5 key. Hold both keys pressed for 5-10 seconds or until
the LCD displays: Exit when done. F1 Set Addr.
2) Press F1 to display current address
3) Set the desired address by entering a number from 1 to 16.
4) Press the Exit key when done.
ENROLLING:
After you have setup all the keypads you will have to Enroll them into the system.
1) Press the ELK key, then press 9 to access the Installation Programming. Press the Right arrow key
to select this menu. The Installer Program Code must be entered to access this menu.
2) Enter the Installer Program Code.
3) The first installer Programming menu displayed will be "Bus Module Enrollment".
4) Press the Right arrow key to select this menu.
5) The M1 transmits an enrollment message to all data bus devices, following by a display showing
the total Bus Modules that are enrolled.
6) Press the Exit key to exit Installer Programming.
Each Keypad should be setup like the following example. To make the F4, F5 and F6 keys work with
the EyeOn system they must be configured with the following settings.