Specifications

47
4.15 LIGHTING: Lutron (080003)
To view the Lutron RA-RS232 setup guide please view the PDF on your EyeOn Technician CD.
Lutron must first be installed in place of all the light switches you would like to control. The EyeOn
system will only add direct control to each light in the house. All sensors can only be accessed at the
switch level. Once you have installed the lights throughout the house, it's important to setup at least
one repeater. The RA-RS232 will communicate directly with the repeater.
Press and hold the ACTIVATE CONTROLS button on any Repeater until the green CONTROLS LED
turns on (about three seconds).
Once the CONTROLS LED is on, press any button on the RA-RS232 device and all the LEDs will
flutter. The display will flash 01 when the RS232 interface has been activated. If the RS232 interface
fails to respond, consult page 68 in the setup guide.
Once you are done press and hold the ACTIVATE CONTROLS button on any Repeater until the
green LED turns off (about three seconds).
The RS232 interface is now activated.
Setting up each light:
The first thing you will have to do is program every light switch into the repeater before you can
program the individual lights into the RA-RS232 device.
To do so, press and hold the ACTIVATE CONTROLS button on any Repeater until the green
CONTROLS LED turns on. (This should take about 3 seconds.)