Specifications

Then, you will walk around the house and turn on or off every light switch you wish to control. When

the light switch is turned on or off, it should blink two or three times to show you that it was accepted.

After you have programmed all light switches into the repeater you can press and hold the ACTIVATE

CONTROLS button until the green LED turns off (this takes about three seconds). You can easily test

all the switches you just programmed into the repeater by pressing the flash button for a few seconds

until the green LED appears. Every light that is programmed through the Lutron system should flash

on and off. If any switch does not flash reprogram it by holding the controls button down again. When

done checking all the lights on the system press and hold the flash button until the green LED turns

off.

Once you have completed the above activation, you will need to activate each light switch in the

house to the RA-RS232 device. Start by simultaneously pressing and holding the Up and Down

buttons until the Select LED turns ON and U1 appears on the display (about three seconds).

Press and release the Select button repeatedly until U2 appears on the display. Press and hold the

Up or Down button to select the Zone Number you want to program. Start with Zone 1 and go up from

there. There are only 32 zones that can be used.

Now you must assign a switch to link up with this zone address. Simply turn the switch On or Off. The

assigned LED will flash for approximately two seconds. The Level LED will then turn On indicating

that the Zone Number is now programmed. Make sure you write this information down.

Repeat these steps again for the remaining Zone Numbers you wish to assign.

To finish the setup stage press and hold the Up and Down buttons until all the LEDs begin to flutter.

It's important to verify a Zone Number assignment, change the status of the switch by turning it On or

Off. The display will flash d followed by the Zone Number assigned.

Once you have verified all the switches you are now done with the Lutron setup.

For advanced diagnostics you can view file Lutron Radio RA-RS232 Protcols on your EyeOn

Technician CD to get a list of the RS232 protocols. This device connects at 9600 BPS 8-N-1.