Specifications

5
1.0 Introduction
Follow the steps outlined in this EyeOn Technician Manual to get your system up and running. Use
the Technician Manual and Quick Start Guides to help you through the initial setup process.
Begin the setup process by installing all hardware that is included in your system. Please referrer to
the manufacturers’ specifications and instructions for installing specific subsystems. Some
subsystems may require pre-configuration. For example, the JDS Infrared Xpander by default is set
for 4800 BPS. This device will not work with the EyeOn server until you switch the jumper. For
troubleshooting the Subsystems please contact the manufacturer of the device.
For each device in
your system, refer to the corresponding section of the EyeOn Technician Manual for these
requirements
.
After all subsystem hardware is setup and installed properly continue to the Administrator Screen
setup. All hardware setup must be complete before you begin setup on the Administrator Screen.
Once all setup is complete the User Screen can be accessed to control your EyeOn automation
system. Information on accessing the User Screen can be found in the User Manual.